Step 1. first things first connect the V1 VCI to the vehicle's obd2 port,
Once connected it will display connected next tap mo which is short for immobilizer
Tap: Immobilizer->>IMMO, and then accept the disclaimer->JEEP
tap automatic selection so that the Autel OTOFIX IM1
can read your vehicle's information immediately since we don't have a working key we just need to turn our hazard lights on
If there is a programmed key, please turn the ignition on.
To execute a function in "Automatic selection", please select the correct vehicle brand.
If it is an old pre-2006 model, please give priority selection to "Manual Selection' or "System Selection"!
Step 3. Read password
Tab ->>Smart key, and then the system will display a password for your keys and will save it in the system then run the scan.
Note : This step need to turn the ignition off and turn on the emergency flashers.
Step 4. Scanning the IMMO Status
Now you should run a scan to make sure there are no fault codes before doing the all keys loss procedure, and please note if there is a programmed key , please make sure the ignition is on and the engine is off
Tab->>IMMO Status can
Our scan comes up normal, so now we can begin with all keys lost
Step 5. Programming all keys lost
Tab ->>ALL KEY LOST
There are 6 steps in All smart Keys Lost guided, Follow the prompts on the screen since we already got the password we don't need to re-read it on step 3
Step 1. Enter system
Step 2. Number of keys
Step 3. read PIN
Step 4. Erase key (The all key lost process will erase all function keys at present )
Step 5. Key learning
Hold your smart key near the center console and click the unlock button a few times until you hear that click -
The screen will display a notification that it is establishing a connection.
Once the connection is established the key is officially learned if you have more than one blank key add them next to or end the process
Step 6. Number of keys lost
will display how many keys you've learned here)
And press escape to go back to the scan page,it's good practice to run a scan after doing all keys lost, run a rescan and see if any codes appear they don't for us
Finally, we are good to go test out keys by locking and unlocking the doors or turning the engine off
programs 2018 jeep grand Cherokee all key lost, success, the works done!
Hope it help, any questions feel free to contact auteldiag support at any time