The opposite of what is going on, creates a vicious circle and eventually leads to: Increase in powder temperature:The particle size distribution is not concentrated-so that the equipment has done a lot of useless work and has not played its due benefit. 8 Before each shutdown, the materials in the hopper must be finished, and the hopper must be cleaned, and then continue to work for 3-5 minutes and then stop according to the stop working procedure.
Each time the particle size or feeding adjustment is performed, the particle size of the material should be tested or re-adjusted after 12 minutes of stable operation. When entering the screen, it is impossible to be screened out in the same unit. Therefore, users need to pay attention to and strictlysingle shaft shredder machine suppliers abide by each of the above-mentioned installation and debugging details in the installation and debugging engineering and technical personnel of our company to ensure the safe and reliable operation of the machine and maximize the economic benefits.
Due to the reduction of the effective area of the screening, the material entering the screen with the increase of unit time is unchanged, and many conform to The material with the required particle size will be discharged from the coarse material port.
Every 5 days of continuous work, the dust bag should be replaced or the powder adsorbed by the dust bag should be knocked out manually to maintain good permeability, so as to ensure stable output and temperature during work. Because the particle size of the finished product is achieved entirely by adjusting the speed of the auxiliary mill (or classifier), rather than being screened out by the screen.